WEEK 5 (FYP 2)

WEEK 5 : Test PIR Motion Sensor

OBJECTIVE :
To test functionality of the PIR Motion Sensor .

METHODOLOGY :
1) set up coding.
2) Check in the Arduino software serial monitor.

RESULT :

Video 5 : PIR Motion Sensor can function.

ANALYSIS & DISCUSSION :
Make sure PIR Motion Sensor terminal rightly connected with the Node MCU port.

CONCLUSION :
The PIR Motion Sensor is working vey well.

WEEK 4 (FYP 2)

WEEK 4 : Testing LED With Blynk Application

OBJECTIVE :
1) To determine functionality of the LED to connect with blynk apps.
2) To test two port Node MCU to connect with LED in parallel connection.

METHODOLOGY :
1) Node MCU connect with WiFi and setting through blynk apps.
2) Set up coding with the right WiFi SSID and passwaord.
3) Set up circuit with the right connection.

RESULT :

Video 3 : LED do not function (do not turn ON) at first trial

Video 4 : LED is function well 

DISCUSSION & ANALYSIS :
During the first test, the LED do not turn ON because NodeMCU cannot be connected to WiFi. The important things in this process is make sure the LED terminal are connected correctly. The positive terminal should connect with Node MCU port and the negative terminal connect with grounding.

CONCLUSION :
All the objectives is achieved.

WEEK 3 (FYP 2)

WEEK 3 : Testing NodeMCU (ESP8266)

OBJECTIVE : 

1) To find the right NodeMCU.

2) To Test the blynk application.

METHODOLOGY :

1) Test the Node MCU using serial monitor in Arduino software.

2) Test blynk apps on Android smartphone.

Results :

Video 1 : Node MCU cannot connect WiFi

Video 2 : Node MCU can connected to WiFi.

Figure 28 : Serial monitor from the first Node MCU

Figure 29 : Serial monitor from the second Node MCU

Discussion & Analysis :

In video 1, the first Node MCU cannot connect to the WiFi, while in video 2, the second Node MCU easily can connected to the WiFi. In a picture 1, we can see from the serial monitor in Arduino software, the first Node MCU cannot connect to the WiFi, while in the second picture, the serial monitor can connect to the WiFi.

Conclusion :

We need to test every hardware that we buy to ensure the hardware is working properly.

WEEK 2 (FYP 2)

WEEK 2 : Compare The Price Of The Components

OBJECTIVE :
1) To avoid paying higher price to the seller.
2) To identify the best price of the components between store.

METHODOLOGY :
1) Identify the store that sell the components.
2) Visit the stores and make the comparison of the price.
3) Searching the price at online store.

RESULT :
I found the components that I want in various price.


ANALYSIS & DISCUSSION :
1) Get to find the product in range of budget.
2) Get to find the product in lowest price.


CONCLUSION :
The objective is achieved because I get identify the lowest price between the stores.

WEEK 1 (FYP 2 )

WEEK 1 : Meeting With Supervisor To Show List Of Hardware

OBJECTIVE :
1) To clarify the hardware need to use in the project.
2) To show the list of hardware that need to buy.

METHODOLOGY :
Show all the hardware that are listed to supervisor.

RESULT :

Figure 27 : List of hardware that use in this project

ANALYSIS & DISCUSSION :
1) All the hardware listed is already confirm by supervisor.
2) Item need in the hardware setup has been minimize for the project.


CONCLUSION :
The objective is achieved and basically all the hardware need for setup the hardware is already done.