WEEK 16

WEEK 16 : CHAPTER 3 (METHODOLOGY)

OBJECTIVES :
1) To know the whole operations that used in this project.
2) To identify the function for each of the component.
3) To completed the project with the specified time.

METHODOLOGY:
1) Built a gantt chart for FYP 1 and the expected gantt chart for the FYP 2.
2) Built a block diagram and flowchart to make a better understanding for this project.
3) Meet the supervisor and ask him to check whether it is correct or not.

RESULT :

Figure 19: Gantt chart FYP 1

 Figure 20: Gantt chart FYP 2

Figure 21: Block diagram 

Figure 22: Flowchart

ANALYSIS AND DISCUSSION :

All the activities that are listed in Gantt chart is mentioned by Sir Zaki. For the block diagram, in short, there have two sensor used. The first sensor is light sensor as a sensor to detect the light. The second one is temperature sensor which is will be function to detect the temperature of surroundings. The Arduino board that used for the project is NodeMCU. In the output side, there have a relay for each types of home devices which are two lamps and a fan. The flowchart is explained from the beginning and then, when the timer at 7pm or 7am , it will check the status of the home appliances which is lamp and fan. After that, it will pass through a relay and then when the time at 7pm the appliances will ON. If the time at 7am the appliances will OFF. However, if the time is not in the specified time, it will receive the signal from Blynk and then it will check the status for each appliances. After receiving the signal, the status will send to the phone.

CONCLUSION :

In this project, we know the whole operations that used in this project. Further than that, we can identify the function for each component. Lastly, we can completed the project with the specified time.