WEEK 12 (FYP2)

WEEK 13 : Make a model for my project and install the hardware into the model

OBJECTIVE :
1) To make a housing cover for my project.
2) To solder my hardware on the strip board.

METHODOLOGY :
1) Prepare the foam board for my house model.
2) Cut the foam board based on house model design.
3) Use a hot glue gun to connect between the foam board.
4) Use a wallpaper to make the foam board is more attractive.
5) Soldering all the components into the strip board.

RESULT :

Figure 40: The house model is completely done

Figure 41: Furniture is install inside the house model

Figure 42: The hardware is install properly inside the house model

ANALYSIS AND DISCUSSION :
The connection on the strip board must be solder properly. Multimeter was used to test the connection. Then, solder pump was used to uninstall the lead nicely. When the solder part is done, install all the hardware in the house model properly. During install the wiring into the house model, it must be not too tight because it will disturb the system. For the model, hot glue gun was used and must not put the glue too much between the foam board. Knife was used during making the model to cut the foam board so that the foam board has a nice cutting. Last but not least, furniture was install inside the house model so that it will make my project more interesting.

CONCLUSION :
As the conclusion, the model and hardware is done properly within the time given.